• Welcome to the Land Rover UK Forums

    You are currently viewing the site as a guest and some content may not be available to you.

    Registration is quick and easy and will give you full access to the site and allow you to ask questions or make comments and join in on the conversation. If you would like to register then please Register Now

changing

  1. Matt_300tdi90

    Troublechanging between high and low range

    Everytime i change from high to low or vice-versa, it never fully engages and i'll drive a few yards then it will pop out of gear. Then it will always engage the gear properly when i try again. Are there any adjustments that can be made to the lever or linkage to correct this? Cheers Matt
  2. Satancom

    Repair Guide Changing A Diff

    After some enthusiastic off roading I lost drive to the front axle, assuming it was just the half shaft I didn't anticipate a large job. How wrong I was. This article assumes you have already removed both half shafts from the axle and drained the oil from the diff. Articles on how to remove...
  3. Satancom

    Repair Guide Changing A Front Half shaft

    Changing the front half shaft is quite an involved job, made worse in my case by having free wheeling hubs installed. Although without the FWH's I wouldn't have been able to get home so they can stay. More often than not the shorter half shaft snaps first, so if your unsure which side has gone...
    • Satancom
    • Resource
    • changing front half shaft
    • Category: Guides
  4. uncle_sam

    Changing Rear Offside Door Lock Mechanism

    For no reason, the lock wouldn't unlock with the central lock switch and remote key fob. Other functions still work, i.e.. still can unlock from handle inside and then door opens with handles inside and outside. Door lock mechanism is non-serviceable and is bloody expensive. Here's how to change...
    • uncle_sam
    • Resource
    • changing door door lock lock mechanism offside rear
    • Category: Guides
Back
Top Bottom