• Welcome to the Land Rover UK Forums

    You are currently viewing the site as a guest and some content may not be available to you.

    Registration is quick and easy and will give you full access to the site and allow you to ask questions or make comments and join in on the conversation. If you would like to register then please Register Now

head gasket replacement

  1. J

    Cylinder head problems

    Hi, I’ve had a problem with coolant getting into the oil in my 2.25l petrol engine. Presuming it was a head gasket problem I’ve done that but the problem persists. Advise me but I guess this is most likely a cylinder head problem - a crack or it’s warped and needs scimming, or both. I...
  2. H

    Knocking after engine rebuild

    First post here, apologies if not in the correct format or place. I've often used the forums for advice for my '76 SIII 88 2.25 Diesel. So far I haven't need to post myself, I can usually get the answer I need from another post..... but I'm stumped... My engineering knowledge is too limited to...
  3. R

    2010 RRS 5.0 SC Autobiography suspected head gasket failure

    Hello all, I own a RRS 2010 AB 5.0. Had for 4 years+ now 145,000 miles, changed nearly everything that typically goes on these (SuperCharger, Active Anti roll bars - front and back, exhaust, cats - both, air height compressor, and to cap it all off replaced the engine - reconditioned from up...
  4. L

    Help!!! Ceased thermostat housing bolt!

    Hi folks! Any idea's pleeeeease!! I've taken the plunge and decided I'll replace my head gasket my self! :p All went swimmingly well until i tried removing the thermostat housing from the head. There are 4 bolts, two at the bottom that just need loosening, and two at the top that need...
Back
Top Bottom