• Welcome to the Land Rover UK Forums

    You are currently viewing the site as a guest and some content may not be available to you.

    Registration is quick and easy and will give you full access to the site and allow you to ask questions or make comments and join in on the conversation. If you would like to register then please Register Now

propshaft

  1. P

    droning noise after replacing front propshaft on discovery II

    Hi New here so be gentle! Had a recent front propshaft failure (at 70 on a motorway, woke us up!!). Anyway had the propshaft replaced with new and underside damage repaired but have a droning sort of sound at 75ish. Does the propshaft need to be balanced are as I have read can it be rotated 90...
  2. boddamese

    Front propshaft clonking on over-run

    My S2 109" is clonking quite badly from what sounds like the front prop when slowing to a stop. There is a bit of play in the sliding joint so I suppose that confirms it. Question is: Although the FWH are engaged, so the prop is turning, would you still expect a prop to make a noise like this...
  3. Bigbananafeet

    Excessive backlash?

    I've spent this afternoon replacing the front output seal on my transfer box as it was leaking/weeping. While doing the job I took a couple of vids of the backlash or play between the front and rear outputs on the box and the diffs. I have a clunk when taking up drive or dipping the clutch when...
  4. B

    What size Propshaft?

    Hi, I need a bit of advice, I have a 1993 110 Hi-Cap, I replaced the rear sailsbury axle with a standard axle, now I find that the rear prop is too short, I need one with an overall length of around 45 inches, (splines compressed) what vehicle would this come from? (the rear prop on my 1985 110...
  5. M

    Front Propshaft: Does a Disco TD5 fits in a Defender 200Tdi?

    Hi everybody! I've got a Defender 200 with 2" lift and my front propshatf is in it's last days... I bought a disco Td5 one (double cardon...etc etc bla bla bla... friends told me)... But is 2" shorter than the original one and the flanges are different... Will it fit? How? Does the length...
  6. LOVELYBOY

    transmission noise + vibration

    I have develped a squeaking noise coming from the transmission under slight load. I have a 4.6 P38 1998 (R plate) It sounds like tweeting birds, (digga-digga-digga-digga) like a dry bearing. It's not all that loud - It seems to be most noticable at about 30 MPH, and I don't think it is engine...
  7. greenbert

    Replacing Propshaft U-joint

    I recently had a go at replacing a seized U-joint on the front propshaft of my SIII SWB. I thought it would be easier than it was, so just want to share my experience. I started off by watching the videos here: http://www.ehow.com/video_2328175_removing-u-joint-from-drive.html It helped a lot...
Back
Top Bottom