• Welcome to the Land Rover UK Forums

    You are currently viewing the site as a guest and some content may not be available to you.

    Registration is quick and easy and will give you full access to the site and allow you to ask questions or make comments and join in on the conversation. If you would like to register then please Register Now

valve

  1. MPi-KMS-72

    Do you suppose i can reuse this valve?

    ha!:D
  2. REDNEFED

    Rear Pads wear - Pressure reduction bias valve needed?

    Defender 90 2.5 200 TDI - 1991 with rear discs. Problem: Rear brake pads worn down after only 10000 miles. When new pads/discs were fitted, the rear locked up during hard braking. Seems to be to much pressure coming from (fairly new) master br. cyl. I want to try fitting an adjustable pressure...
  3. Q

    Recurrent head gasket failure 300Tdi

    I have an M-reg, 1995m 300 Tdi, and in the last year I have a series of head problems. When it last failed in November, I tried to fix the root cause, so I changed the radaitor, water pump, theromostat and sensors, but it has just gone again. I caught it quickly and it did not overheat...
  4. Pete H

    Valve Clearances 200/300 TDi

    Tools needed: 1/2 inch ratchet 1/2 inch breaker bar 1/2 inch ring spanner 8mm socket 13mm socket 27mm socket 32mm viscous fan spanner Flat blade screw driver. To do this job you will need to remove the top radiator hose (you will lose a little coolant), also you will need to remove the hose...
    • Pete H
    • Resource
    • 200 tdi 300 tdi clearance valve valve clearance
    • Category: Guides
Back
Top Bottom