• Welcome to the Land Rover UK Forums

    You are currently viewing the site as a guest and some content may not be available to you.

    Registration is quick and easy and will give you full access to the site and allow you to ask questions or make comments and join in on the conversation. If you would like to register then please Register Now

How Do I? A-frame Ball Joint Removal

Larry , have only ever done it once , but i took the whole a frame off . I was going to do the bushes as well .
On the rangie you can remove the two big long bolts either side of the ball joint and the small section that secures and includes the joint comes away .
Next i was lucky and had some heat to loosen things off . Basically batter the ball joint out the way it came in :) . Clean everything up really nice and then put the new one in . I made up a spacer with some pipe so i could use my vice as a press . The spacer is essential to save damage to the joint . I think i used 2 inch pipe .
Press the new joint fully in .
 
Back
Top Bottom