• Welcome to the Land Rover UK Forums

    You are currently viewing the site as a guest and some content may not be available to you.

    Registration is quick and easy and will give you full access to the site and allow you to ask questions or make comments and join in on the conversation. If you would like to register then please Register Now

Engine/gearbox mount removal

tagnut69

tagnut69

In Fourth Gear
After looking at the mounts for the engine and gear box as suggested for another problem, I am going to replace them, they look as old as the truck they are on and proberbly wernt changed with the galvanised chassis, many moons ago.

So is it an easy job and do I need an engine hoist or wil a trolly jack do just to lift it where I need to and slide out the old and pop in the new ones.

Should I go for rubber original type or the new poly jobbies

Thanks in advance

Chris
 
So is it an easy job and do I need an engine hoist or wil a trolly jack do just to lift it where I need to and slide out the old and pop in the new ones.

Yes easy job and a trolley jack will do fine.



Should I go for rubber original type or the new poly jobbies

Didn't know that poly type were available, but on suspension polys Blue is claimed by the manufacturer to be equivalent to rubber.
 
Back
Top Bottom