• Welcome to the Land Rover UK Forums

    You are currently viewing the site as a guest and some content may not be available to you.

    Registration is quick and easy and will give you full access to the site and allow you to ask questions or make comments and join in on the conversation. If you would like to register then please Register Now

i need a good old fashioned length of pipe.

nobber

Extreme Landy Fan
so i can plumb in my oil cooler , Ive seen fuel pipe here and there but no oil pipe , where can i get some guys?
also on most oil cooler pipe work steel pipe has been used for straight runs and hose p bends , is this necessary?
 
so i can plumb in my oil cooler , Ive seen fuel pipe here and there but no oil pipe , where can i get some guys?
also on most oil cooler pipe work steel pipe has been used for straight runs and hose p bends , is this necessary?

Yellow Pages
Look for a hydraulic specialist.
Some are more helpful than others :D
 
so i can plumb in my oil cooler , Ive seen fuel pipe here and there but no oil pipe , where can i get some guys?
also on most oil cooler pipe work steel pipe has been used for straight runs and hose p bends , is this necessary?

What's wrong with a bit of 15mil copper and a few end feed fittings Rob?:D

Roger.
 
What diameter pipe are you looking for and how are you intending to rework it if it comes in straight lengths??????:confused:
 
I wonder if the braided pipes you connect up an oil boiler burner would fit.
I hav meant to bring one home to see.
 
i was looking for some flexi rubber pipe, ive got loads of fittings , 90/45 bends if i cant get the rubber hose to go around corners.
ive seen fuel pipe in various vehicle parts web sites , would fuel pipe work for oil?
 
any tractor dealer will make the pipes up for you while you wait ,there is no great pressure involved so ordinary hydrualic hose would do .just measure the lenth and know what ends you need and it should only take 10 minutes:)
 
These guys may give you an idea what you can get browsing the site

http://www.merlinmotorsport.co.uk/index.html

Pirtek may have somewhere near you or hydraulic specialist in your nearest industrial estate will do hydraulic seamless tube and bend it for you.......ask price first......... some of them have huge windows:D
Would hoses at bends be for allowing movement.....like at master cylinders ..fuel tanks etc
Alex
 
Back
Top Bottom