I have lined up dot on fuel pump and camshaft with respective arrows on casing and set at top dead centre by aligning woodruf on crankshaft with arrow on casing....but this just leads to valves impinging with pistons.
Have tried to to dislodge bolt on top of bell housing next to oil vent out-put hose leading to rockerin order to drill hole in. but this is rounded will not budge. cant find other means of getting TDC.
What am i doing wrong?
Have tried to to dislodge bolt on top of bell housing next to oil vent out-put hose leading to rockerin order to drill hole in. but this is rounded will not budge. cant find other means of getting TDC.
What am i doing wrong?